1 Whole Fryer, cut-up (I like to cut each chicken breast in half so that all of the chicken pieces are about the same size. They will cook all the way through in about the same amount of time that way without burning.)


For the brine:
2 cups of buttermilk
2 Tablespoons kosher salt
1/2 teaspoon black pepper


For dipping the chicken:

2 eggs
1/4 cup Texas Pete Hot Sauce (this will not add heat to the chicken, only flavor, the heat will cook out)


For coating the chicken:

2 cups of all-purpose flour
1 Tablespoon kosher salt
1 teaspoon of Accent
1/2 teaspoon black pepper
1/2 teaspoon cayenne pepper
1/2 teaspoon ground sage
1/2 teaspoon paprika
1/2 tsp ground coriander
1/4 tsp ground thyme
1/4 tsp garlic powder


1 gallon size Ziploc freezer bag
Peanut Oil for frying


Combine the buttermilk, 2 Tablespoons salt and the pepper.

Place the chicken parts in a glass baking dish.

Pour the buttermilk mixture over the chicken. Turn to make sure that each piece of chicken is thoroughly coated.

Cover with plastic wrap and refrigerate for at least a couple of hours but it's best if you can let is soak overnight.

After the chicken has finished marinating, pour the chicken and buttermilk brine into a colander to drain off the buttermilk. Allow to sit for about 15-20 minutes to drain and warm up a bit.

In a large (gallon size) plastic Ziploc bag, combine all of the coating ingredients (flour, salt, accent, pepper, cayenne pepper, sage, paprika, coriander, thyme and garlic powder). Mix well.

In a shallow dish, mix together the eggs and the hot sauce, set aside.

Drop the chicken pieces, one or two pieces at a time, directly into the flour mixture (don't put it in the egg mixture just yet, that will come in a minute). Shake off excess and place on a baking sheet or plate until all pieces have been coated with flour.

Next, dip each piece of flour coated chicken into the egg mixture.

Return to the flour mixture and shake ( no more than 2-3 pieces at a time) to coat well. Allow to sit on a plate or shallow baking dish for about 15 minutes so that the "crust" will stick to the chicken.

Heat peanut oil to 350 degrees F.

* If using an electric deep fryer, follow the manufacturers' directions.

* If using a dutch oven, fill with 6 to 12 cups but no more than 2/3 full of peanut oil.

* If pan-frying, you'll need a heavy bottom skillet (I recommend cast iron) with about an inch of oil.

Slowly drop the chicken in the HOT oil starting with the dark meat first. Don't get in a big hurry putting in the chicken because you don't want to lower the temperature of the oil too quickly as this will cause your chicken to soak up the oil and be greasy (not a good thing). The temperature of the oil is going to drop to about 300° or so once you put your chicken in. This is the temperature that you want to try to maintain while the chicken cooks.

Fry 3 to 4 pieces of the chicken at a time for 12 to 15 minutes, or until each one is golden brown. Be sure to turn the chicken halfway through the cooking time so that each piece cooks evenly.

Remove the chicken to a rack, paper towels or brown paper bags to drain for about 5 minutes. Put the finished chicken onto a shallow baking sheet and put in a preheated 225°F oven to keep warm while the other pieces are frying.


The cooking times will vary but as a general rule:
(These times are for bone in chicken. Boneless will take only about half the time depending upon the thickness.)

*13-14 minutes for dark meat
*10-12 minutes for white meat

*NOTE: You can see step-by-step pictures HERE

I think I posted this in the wrong place. Could one of the moderators move it to poultry recipes? Sorry....I'll get the hang of this place shortly....I hope LOL.